Upcycled Pengins

As always, my final Christmas card of the year is the one I've made for Steve.  Whenever he buys me a card he chooses one that he knows I'll upcycle.   Last Christmas he sent me a lovely tunnel card with cute penguins.  I've made this Christmas card for him using the image from the card but inserted the layers into a die cut frame.

To make this card I used:
     6" x 6" white hammer card blank
     Upcycled Christmas card
     Lawn Fawn 'Outside In Stitched Square Stackables' and Crafter's Companion 'Gemini Expressions - Husband' dies
     Snippet of white hammer card, thin white card and gold mirri

I cut the snippet of white hammer card so it was slightly smaller than the card blank and die cut the stitched square from the centre.   As I was going to insert two layers of card into the aperture and wanted the bottom layer flush with the front of the card, I cut a snippet of thin white card so it was slightly smaller than the panel and die cut a square from the centre.  These panels were layered and attached to the centre of the card.  I die cut the snow and sky panel from the original card and inlaid it into the aperture.  I then die cut the penguin image and inlaid it into the lower section of the aperture.  To finish I die cut 'husband' from a snippet of white hammer card and the frame from gold mirri.  These were layered and attached to the lower corner of the image.

I am entering the following challenges:
     ABC Christmas Challenge - Z for Zoo Animals (my cute penguins)
     As You Like it Challenge - Anything Christmasssy
     Cardz for Guys - Christmas Card
     Crafty Calendar Challenge - Christmas
     Krafty Chicks Challenge - Christmas
     Merry Little Christmas Challenge - Anything Christmas Goes
     The Male Room - Anything Goes

Kath x